Filter Wireless Clients – (DGL-4300) Select this option to apply the MAC filter settings to the wireless interface.Mode – Select only allow listed machines to only allow listed computers to connect to the gaming router or only deny listed machines to allow all computers to connect, except for those listed.Step 4 In the Filter Settings section select MAC Filter Enabled and configured the following: Step 3 Click Advanced at the top and then click MAC Address Filter on the left side. Step 2 The default password is blank (nothing). Step 1 Open a web browser and type the IP address of the gaming router in the address bar (default is 192.168.0.1). If you would like other computers also can access the Internet,please click Add New to add new rules.Please note one rule can be setted one MAC address.MAC filters will allow you to allow/deny access to wired and wireless clients based upon the clients MAC address.
Then this computer which MAC Address is setted can access the Internet via the router. Step 9 Type the MAC address of the computer which can be allowed to access the Internet in the MAC Address bar.Set the Status as Enable. Step 7 Click Security->MAC Filtering on the left of the page. Then these computers whose MAC address are setted in the rules will have the right to access the Internet.Otherwise please select Deny these PCs with enabled rules to access the Internet. If you just would like to allow some computers to access the Internet,please select Allow these PCs with enable rules to access the Internet. Step 5 Select Enable Firewall(the feneral firewall switch),and select Enable MAC Filtering. Step 4 Click the Security->Firewall on the left of the page. Step 3 Type the username and password in the login page, the default username and password both are admin. Step 2 Open the web browser and type the default access of the router （like 192.168.1.1) into the address bar and then Press Enter. (2) Type ipconfig/all at the prompt window, press Enter, it will show the MAC address and other address information of this computer. (1)Click Start->Run, type cmd and press Enter. Step 1 You should know the MAC addresses of the computers which you would like to allow them to access the Internet.You can check them on the computers with command prompt. If you would like to limit which computers can access the Internet through the router,you can set MAC Filtering to achieve it.
0 kommentar(er)
